Velux KLR 100 Bedienungsanleitung PDF herunterladen (Seite 33)

64 VELUX VELUX 65

A B









Yes No



ENGLISH ENGLISH

Resetting and preparing for registration

The skylight can be reset to its initial factory settings

and then be prepared for registration.

To reset the skylight, make sure that it has been closed

by inserting a pointed object in the skylight operator

cover hole marked A and pressing brieﬂy.

When the skylight is closed, press with a pointed

object through the operator cover hole marked A for

at least 5 seconds. The skylight operator and other

electrical products connected to the skylight will run

brieﬂy back and forth indicating that they are ready to

be registered.

Note: A reset removes the connection between the

skylight with its electrical products and all remote

controls. Therefore the products cannot be operated

until they have been registered in a remote control

again. To reinstate the connection between product

and remote control after reset, please refer to the

instructions in section Initial set-up.

The remote control can be reset to its initial factory set-

tings if you want to delete all registered products and all

programming and start afresh.

Slide o the battery cover as shown.

Press the button on the right side of the remote control

with a pointed object for at least 5 seconds.

Replace the battery cover.

Press "Yes" to conﬁrm that you want to reset the

remote control.

The remote control has now been reset. To reinstate the

connection between remote control and products, please

refer to the instructions in section Initial set-up.

Resetting the remote control

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 110 111

Keine Kommentare

Velux KLR 100 Bedienungsanleitung Seite 33